Chan needs help (hand brake)
#3
Re: Chan needs help (hand brake)
the handbrake is different
the rear master cylinder looks good but Im not sure on the handbrake itself. I think the magura that you have isnt gonna cut it. You need to order the other one or a nissin. Im just running a 900rr one flipped. You can even use a 929 or 954 if you got one.
It should still bleed but I remeber when manny had the same setup it would get soft. You would have to pump it up to get it hard again lol.... that doesnt sound right hahahahaha
I think your best bet would be to run something else. For some reason those maguras dont work all that well. Hope this helps man.
EDUB
the rear master cylinder looks good but Im not sure on the handbrake itself. I think the magura that you have isnt gonna cut it. You need to order the other one or a nissin. Im just running a 900rr one flipped. You can even use a 929 or 954 if you got one.
It should still bleed but I remeber when manny had the same setup it would get soft. You would have to pump it up to get it hard again lol.... that doesnt sound right hahahahaha
I think your best bet would be to run something else. For some reason those maguras dont work all that well. Hope this helps man.
EDUB
#5
Re: Chan needs help (hand brake)
I think it is cause the magura only has a 10.5 piston which isn't quite enough to run the caliper. The one you guys run is like 14 or 13 i think. I love how small the magura one is though. I guess i'll try some thing different for now until i can get the magical puertican to help me and then if this doesn't work then its done.
#6
Re: Chan needs help (hand brake)
Originally Posted by E-DUB OM
i know you have to have a front brake master cylinder laying around somewhere
#7
Re: Chan needs help (hand brake)
Originally Posted by Zackie Chan
I think all mine might be broken put i'll use a gixxer one if i have to.
throw that bad boy on, bleed the bastard, and go out and kill it......
you'll thank me for it later lol
#8
Re: Chan needs help (hand brake)
Originally Posted by E-DUB OM
I hear the gixxer ones work just as good
throw that bad boy on, bleed the bastard, and go out and kill it......
you'll thank me for it later lol
throw that bad boy on, bleed the bastard, and go out and kill it......
you'll thank me for it later lol
#10
Re: Chan needs help (hand brake)
Got the 900rr master on and it works good but the clearance is giving me some trouble. I am haveing a hard time turning the brake and the clutch lever down. I ate **** hard cause i couldn't pull in the clutch when i high sided a circle. I will just have to take the grinder to it and see what i can do. Thanks for the help slim shady.
#11
Thread
Thread Starter
Forum
Replies
Last Post
greenhornet347
Bike Parts for Sale
5
03-24-2013 12:22 AM
f4i knight
Bikes for Sale
7
02-26-2013 03:06 PM
OneWheelRegulator
Super Moto/Motards...
1
12-02-2012 01:25 AM