mangura hb problem
#1
Waiting For Email Confirmation
Thread Starter
Join Date: Feb 2008
Location: Back In sunshine,O town fl
Posts: 257
mangura hb problem
hey , i just got a mangura from bill at full throttle, i have the four pistopn set up...my problem is , i was bleeding the damn hand break for about 2 hrs and the mangura has pressure , but its still squeezin in the the handle bar..i see the piston in the back moving and sqeezing, but the damn manura is not getting hard...am pretty sure i took all the air out the system..and all the bolts are tight....can some body help me out
#3
Re: mangura hb problem
take the caliper off and squeeze the brake until the pads collapse then fill the bottle back up, take a flat head pull the brake pads out enough to put back on the rotor then re bleed the system. This is what I did when I had the same problem.
#4
Waiting For Email Confirmation
Thread Starter
Join Date: Feb 2008
Location: Back In sunshine,O town fl
Posts: 257
Re: mangura hb problem
Oo oka .I took it off the caliper n just stuck a wrench in it .I was bleeding it over n over like this . Then wen input it bac on .the lever felt twice as hard .the only thing I dint do was rebleed it .but am rebleed it tomor ..thanks tho man
#5
Re: mangura hb problem
you need to bleed the master as well with the bleeder right side up if its a right handed master. also need to have the caliper with the bleeder in an upright position to get all the air out.
Thread
Thread Starter
Forum
Replies
Last Post
--*CBR*KING*--
General Sportbike Discussion
2
04-05-2022 11:42 AM
alex71783
General Sportbike Discussion
0
08-09-2015 02:18 PM
Duke_Montes
Service, Repair, and Maintenance
0
07-23-2015 11:12 PM