06 636 advice
#1
06 636 advice
tried circles,dropped bike on a curb didnt have a cage on it . i broke the stator cover in pieces, took that off and realized i f'd the stator also. the housing (or whatever its called) that the stator fits into is bent also. ok those i can get here and there for a few bucks nothing too expensive. BUT the damn lower case is broke also (see the pics) see where the cover bolts on, can i have someone aluminum weld and fill the gap then drill and tap it? also it looks a little bent as well, the gears in there are not touching the case but im not sure if its bent enough that when i put a new cover on it it wont line up. any advice and help please
[ATTACH][ATTACH][/ATTACH][/ATTACH]
[ATTACH][ATTACH][/ATTACH][/ATTACH]
#2
Re: 06 636 advice
im pretty sure you can have that welded. ive seen ppl just use jb weld on it too. and good luck findining a cheap stator and rotor... i did that to my first 636 and the parts retail at 389 dollars each!! i got lucky and found a racer guy in texas to sell me both for 200.
#4
Re: 06 636 advice
im pretty sure you can have that welded. ive seen ppl just use jb weld on it too. and good luck findining a cheap stator and rotor... i did that to my first 636 and the parts retail at 389 dollars each!! i got lucky and found a racer guy in texas to sell me both for 200.
#5
Re: 06 636 advice
i wouldnt jb weld it my experiances with jb weld are that its not a long time fix. its a "get home" fix lol. there is a high performance engine building shop down here in sioux city that would weld it up pretty cheap had the guy do a couple of mine. see if there is anything like that closer to you. and good luck on getting stator and rotor Expensive get a used set lol
Thread
Thread Starter
Forum
Replies
Last Post