1brownj

HAVING TROUBLE FINDING THE BEST WAY TO ROUTE MY THROTTLE CABLES ON THE F4I,,INSTALLING DIRT BIKE BARS AND CANT GET FULL SWING ON MY STEERING??? CAN SOMEONE POST UP A FEW PICTURES AND ADVICE?? THANKS

50slut

i ran my cables like this, and had my throttle housing turned up, so starter button was on top and kill switch faced 4ward.........

[IMG][/IMG]

1brownj

looks good thanks,,does that bind up while turning?? i was about to try and cut my db bars down a little at the ends to move the throttle inwards some?? would anybody recommend this to achieve full steerability?? it works ok right now but binds up only when i turn from stop to stop.

50slut

you can cut the bars down a bit also, i did that on my 600RR db bars and i like it. but no no problems with cables binding up on the bike i posted a pic of

ToKwik

Not sure if it helps you or not, but here is the original factory routing.

Might give you some ideas with the DB setup.

Give me a buzz if you need the whole manual.

highstrung810

is there a way I can get this image having the same issue right now?