rider0033

well this is my first write up and i still need to finish it, but i'll post up the rest later. first i took a long look at the bike to get my ideas straight.
http://www.sharenow.com/base/content/12455/

unbolt the exhaust can, mine had three bolts
http://www.sharenow.com/base/content/12456/

remove the can (i like the look without)
http://www.sharenow.com/base/content/12457/

grind the rivets off to remove the cap (if yours have rivets)
http://www.sharenow.com/base/content/12459/

measure the can for your desired length. take a piece of paper or magazine spine and bend it around the can to get a straight line
marking. then mark your line around the can. rotate the can 3 inches at a time measuring each time to make sure your line is straight.
http://www.sharenow.com/base/content/12461/

make sure to stay away from useless tools like the ones that got me stuck this weekend
http://www.sharenow.com/base/content/12460/

so this is how i rode it to work today and i will post the rest of the pics when i am finished
http://www.sharenow.com/base/content/12462/

Timmy P

dremel tool useless.. tell me your kidding. and whats the finished project look like.. I didnt see a finished picture. just a bike with no can on it.

rider0033

READ and yes the dremel was useless for this project unless i wanted to stay there all night. smarter not harder

Wetley

just cut mine, but turns out the middle pipe (no idea what its called) is jammed pretty ****** good into the cap...like hard core. hooked it up to my vice and pulled and pulled. so now i gotta figure out what i gots to do next