f4i acerbis headlight install
#3
Re: f4i acerbis headlight install
What I did is used the low beam lights on my harness, I believe they were red and black, and connected those to the small low beam light on the acerbis harness. Then I used both bigger bulbs to my high beam wires off my harness.
That way when I turn my bike on I have the small light on as my low beam, then when I turn on my high beam both bigger bulbs turn on.
The wiring is pretty easy, just look at your stock lights, find the low beam wires and then cut and strip them, then connect them to the wires coming out of the small bulb. (I soldered mine together) Then find the high beam wires and cut and strip them, then connect them to both bulbs, so it would be two powers and two grounds going into one power and one ground coming from the harness. I blew a fuse during the process, I talked to acerbis and they said because of the watts that the bike puts out or something, but the fuse box is located under the seat and usually is a little 10amp fuse, easy to replace. ( if that happens to you) I was drunk when i did it,
That way when I turn my bike on I have the small light on as my low beam, then when I turn on my high beam both bigger bulbs turn on.
The wiring is pretty easy, just look at your stock lights, find the low beam wires and then cut and strip them, then connect them to the wires coming out of the small bulb. (I soldered mine together) Then find the high beam wires and cut and strip them, then connect them to both bulbs, so it would be two powers and two grounds going into one power and one ground coming from the harness. I blew a fuse during the process, I talked to acerbis and they said because of the watts that the bike puts out or something, but the fuse box is located under the seat and usually is a little 10amp fuse, easy to replace. ( if that happens to you) I was drunk when i did it,
Thread
Thread Starter
Forum
Replies
Last Post
01SSNBM
Bike Parts for Sale
5
02-18-2013 08:14 PM