929 Clutch Still Slipping...any Ideas?
#1
929 Clutch Still Slipping...any Ideas?
MY CLUTCH WAS RECENTLY SLIPPING (NOT BAD) AT THE TOP OF 4TH,5TH ETC...
SO A REPLACED THE CLUTCH PLATES AND FIBERS WITH NEW ONES. BIKE IS STILL SLIPPING WHEN I PUNCH IT(ONLY AT THE TOP OF THE GEAR, 9,000RPM's+)4TH,5TH,6TH.
IT SLIPS THEY SAME (NO MORE/NO LESS)AS IT DID WITH THE OLD CLUTCH.
I HAVE PLAYED WITH THE CLUTCH CABLE ADJUSTERS ON BOTH ENDS AND STILL CANNOT FIGURE OUT WHY THE SLIPPAGE
ANY ONE GOT ANY IDEAS
SO A REPLACED THE CLUTCH PLATES AND FIBERS WITH NEW ONES. BIKE IS STILL SLIPPING WHEN I PUNCH IT(ONLY AT THE TOP OF THE GEAR, 9,000RPM's+)4TH,5TH,6TH.
IT SLIPS THEY SAME (NO MORE/NO LESS)AS IT DID WITH THE OLD CLUTCH.
I HAVE PLAYED WITH THE CLUTCH CABLE ADJUSTERS ON BOTH ENDS AND STILL CANNOT FIGURE OUT WHY THE SLIPPAGE
ANY ONE GOT ANY IDEAS
#3
#4
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: 929 Clutch Still Slipping...any Ideas?
the race spring are super strong and make your clutch pull hard as hell but i can do the clutch release lever mod for you just give it to me the next time we ride and i will extend it for you if it slips with race springs then some thing is warped in there
#6
#8
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Thread
Thread Starter
Forum
Replies
Last Post
odkpj56
Stunt Discussion
0
04-23-2013 03:16 AM