nickalltogether

So I've got new steels and fibers coming for my 06 f4i, hoping to have them tomorrow. The only question I have is what should I do to prep them to go in, I've heard soak the fibers in oil and scuff the steels... that sound right to everyone?



ps-don't buy bikes from dumbass squids.. otherwise you'll be replacing the clutch on a bike w/ 3k miles

f4ibry

ya man basicall soak those bitches half day or as soon as u get them...

drain oil pop case and remove, and replace the fibers...

did u get springs and steels too or just fibers? u prolly only need fibers.

nickalltogether

i got steels too... my stock steels are straight blue... i've already had them out once, i sanded them down but it didn't help.

f4ibry

good, then u know wut ur doin...jus do it

make sure n break that clutch in a bit, speccially with new steels, make sure u heat and cool it several times before u bash on it...

Wheeliest

like at least 500 miles before clutching **** up.

nickalltogether

i rode it about twenty minutes and clutched it up haha. rode today too and everything is still good.

YSRRider

not sure about the f4i's...... on the 900RR's the factory shop manual says to put all the metal discs in with the rounded edge IN..... the plates are stamped out, so there is a sharp edge and a rounded edge.....

I suggest putting them all in the same way.