stunta600rr

when u swap the clutch lever there is 2 wires coming out of the stock clutch piece going to the horn and dirctional box. What do u do with the wires?

Fuzzy Nutz

If it's the same as my Superhawk just jump the two wires together... I haven't gotten that far with my F4i build to know for sure but all you have to do is try to start it with them disconnected... if it don't start jump the wires together...

stunta600rr

u dont do anything it starts and runs with them disconnecced.
thanx

stick1300

Yeah, we just installed an EZ pull on my buddies F4i last weekend and we just left them unhooked.

Towlieee

Hook them up!

The bike wont start in gear


And if you run your idle up, you will destroy your tranny forcing it into gear after you start the bike!

stick1300

So should we go back and just jump them together?

Towlieee

ya tie em together

best way IMO

Just make sure its not in gear when you go to start it

stick1300

Ok. What exactly do they do?

Fuzzy Nutz

It's for a "dummy" switch... just like the kickstand "dummy" sensor... keeps you from doing dumb things like trying to start the bike in gear without holding the clutch...