636 rear wheel swap
#21
Re: 636 rear wheel swap
It would be if they made it 13mm narrower from both ends, but its not. Just the right side is pushed in 13mm, both the bearing and rotor mounting surface are 13mm in to the left from the 03/04.....
#22
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: 636 rear wheel swap
hhmm ok i get it now...so the center of the rim relative to the sprocket remains the same..
#23
#24
#25
#27
Re: 636 rear wheel swap
You should run a 190 or bigger on a 6", some 180's might fit but they wont be proper. The profile will be way flattened out Id think, Im not sure thou cause Ive only run 180s on 5.5" and 190 on 6"
#33
Re: 636 rear wheel swap
How is the 520 setup on the 636s working out. Has anyone been doing 525 conversions? I couldnt imaging the 520 holding up for very long.
Not trying to thread jack. Just seems like a good place to ask.
Not trying to thread jack. Just seems like a good place to ask.
#34
Re: 636 rear wheel swap
#38