Trachito

my Powers cage has a crack at one of the welds. the weld thats cracked is located on the front part of the cage where it mounts onto the frame. Recommend rewelding it or will that weld make the material weaker? would it matter if its tig or mig welded for this application?

juzslidin

i just had a buddy reweld my powers cage with no issues so far . if u cracked 1 weld there are prob more . sand blast the cage and check the rest of it out . as to rewelding i do it .... but im a broke stunter

LynchMob

hey dont have a warranty on there welds?

Seal Clubber

welding wont hurt if its done right and tig will be stronger, take it to a welding shop...

xxMICKEYxx

i broke my powers this weekend and this is the second time it broke at the top the first time, and at the bottom this time

Trachito

cool. thanks for the info fellas. i'll see about taking it to my boy's shop.

u had it rewelded or just ran with it cracked until it gave out?

Endo Andy

my friends powers cage cracked, he spoke to a rep at clutch control and they told him they would replace it, so try contacting them. the most it could cost ya is the shipping!

xxMICKEYxx

i had it rewelded the first time too

Trachito

at least the first weld held with no probs. that's a good sign.

MikeM

Its steel. you can weld it as many times as you want

WristTwister567

Dont be a cheap ***. Buy a new one!

madandyuk

if its steel or ali it can be welded just make sure to penetrate the metal well if it sounds like bacon frying then its doing good as long as you heat it up use almost full powerr setting but not as much wire you should be in the good

jakesfords

just have them send you a new one if you bust the weld they should replace it

xxMICKEYxx

will they actually replace it if it's broken? the first time it broke because their weld was shitty, this time i broke the angle iron on the bottom.