DCP-TED

My FI cage stripped my motor mount thread so I did the nut and bolt all the way thru, well the bike went down and landed on the slider and pushed the nut on the inside into the back of the case leaving a small hole that leaks oil slowly. Now how can I fix this? Will a marine epoxy or some kind of super high temp material patch this? what works good on the case and is it cast aluminum? What will fix this?

old man roger

get rid of the fi cage and jb weld the case

DCP-TED

jb weld wont eventually flake off from the heat Roger?

old man roger

i have seen people jb weld big chunks of crank case back together.....lol

if you use the regular jb weld not the jb quick it will last forever....

DCP-TED

Thanks for the info, I was thinking jb but was unsure about the heat. Thanks again.