Snd gear wheelies
#1
Registered User
Thread Starter
Join Date: May 2003
Location: Edinburgh, scotland, UK
Age: 46
Posts: 32
Snd gear wheelies
Right I'm riding a '99 ZX-6R with -1F +3B
No probs bouncing it in 1st but I want to do it 2nd and all I get is a little bite then nothing where am I going wrong, I can ride in 1st until i hit the rev limiter.
Any hints or tips about getting it up then??
Also about finding the balancing point - how do I know when I am there and how much of a margin of error do I have??
Macca
No probs bouncing it in 1st but I want to do it 2nd and all I get is a little bite then nothing where am I going wrong, I can ride in 1st until i hit the rev limiter.
Any hints or tips about getting it up then??
Also about finding the balancing point - how do I know when I am there and how much of a margin of error do I have??
Macca
#2
with that set up, you should not have a problem, i was lifting a 99 R6 stock in second, i'd say just practice, its all timing as you feel ther bounce start to come back gas it hard and it should come up.
#3
Registered User
Thread Starter
Join Date: May 2003
Location: Edinburgh, scotland, UK
Age: 46
Posts: 32
I've been trying and trying but as soon as I pull on the gas again it just dies & it goes no where as if there is not enough torque!!
At what rpm are you coming back on the gas??
any help appreciated!!
At what rpm are you coming back on the gas??
any help appreciated!!
Thread
Thread Starter
Forum
Replies
Last Post