f4 wont start after cct installed
#1
f4 wont start after cct installed
I put in a manual cct on my bike now it turns on but wont start. I know it's not the cct causing the problems. There is a clicking noise coming from a little box to the side of the battery. I checked the fuse in it (30 amp) and it's not blown. I made sure that I reconnected the plug right above the cct, and the two wires that go into the bottom of the gas tank and all the hoses, the fuel is turned on too. Any ideas?
#3
Re: f4 wont start after cct installed
That little box thats clicking is your "starter relay"
9 times out of 10 if its clicking like that, its because your battery is dead....
Did you forget to turn off the ignition while you were workin on the bike?
9 times out of 10 if its clicking like that, its because your battery is dead....
Did you forget to turn off the ignition while you were workin on the bike?
#6
Re: f4 wont start after cct installed
#8
Re: f4 wont start after cct installed
I did use the instructions from the cbrworld site, they were handy although I did find a way so I could use my 3/8 drive, I didn't have a wobble for my 1/4 drive.
Thread
Thread Starter
Forum
Replies
Last Post
01SSNBM
Bike Parts for Sale
5
02-18-2013 08:14 PM
iRiEsTuNtAh!
Bike Parts for Sale
4
01-20-2013 10:35 PM
crew72
Bike Parts for Sale
2
12-27-2012 01:44 PM