rekd636

recently took my cage of my 636 and must have moved it around to much with the motor mounts out...the motor dropped down slightly and when i went to put frame sliders on the holes didnt line up any advice on how to get the motor back up into place...i tried jackin it but it didnt really go much

binder929rr

first, don't remove both sides at the same time dummy.

take the exhaust off and use a floor jack.

ahenry

ha ^^^^^ what he said, and move the jack around a couple times, angles come into play

E-Loc540

you may have to loosen all other motor mount bolts first...........

jakesfords

all of the above

old man roger

or just use a long punch in the hole that is closest to where it needs to be and pry up to get the other hole so you can get the bolt in and then that should let you get the bolt in the other side too....

or you could do it the way they said either will work just think the punch way is quicker

-SKETCHY-

+1 thats what I always do.My last 636 was so jacked up if I took 1 motormount bolt out the motor would shift down 1/2 inch.

Wheeliest

your guy's ***** all fucked up.