center clutch help??
#1
center clutch help??
so i was doin the clutch on my f4i did everythin right..had my inch lb torque wrench out..started to tighten down the clutch spring bolts..got everyone of them and on the last one..the F**#ckin thing snaps..so i have over half the bolt in the center clutch and the rest of the screw on the ground..besides taking off the whole assembly?? i dont have that special tool to hold the clutch hub anyways..any ideas?? i would drill it out but then i'd just be screwing myself later..help asap would be nice..
#2
Re: center clutch help??
man, that happened to me - EXACTLY! the last one snapped...you don't have to take all apart, I just took small thin pin and made a little hole in it (screw left in) on the edge and did small hits with the hammer to turn it for one-two rotations until I could catch it with plyers (think this is the right term)...if this doesn't succeed you can drill it but it's hard without putting it on the table so you don't screw up the thread...sorry if you don't understand but I can't explain it better...
Thread
Thread Starter
Forum
Replies
Last Post
ACTION
Bike Parts for Sale
1
09-16-2013 05:24 PM