edro

Recently I changed the crank gasket on my CBR 600f4i. I started it to check if there was any more leaking oil and after I discovered that there was not, I put the fairing back on and tried to start it and it would not start. It will turn over, but it just wont fire. I looked at all of the wiring thinking that I knocked something loose and there was none. I checked the stator and found 2 of the sides had a little bit of burnt material on them. Could it be the plugs, they are a ***** to change? Battery is fine, ignition coil and connectors fine. Any advice anyone.

MikeM

does the fuel pump prime?

edro

how can you tell that?

Wheeliest

lol what u need to do is get a bike that runs.

MikeM

when you turn the key and the switch to On, you should hear a small electric motor sound for 2 or 3 seconds

DEBO

Kill switch on, u here the fuel pump

edro

My fuel pump is priming then.

MikeM

ok then the fuel supply is probably good

that leaves spark and/or compression

terrible1

Make sure you have spark, compression and last but not least timing.