wtf is it..
#1
wtf is it..
my f4i still wont throw spark,ive replaced the cam sensor,the igntion pulse sensor,the igntion,the cdi box,relays,rectifer,and wiring harness,coils and coil harness...everything appears to be plugged up...wtf else would keep it from sparking..
#4
Re: wtf is it..
in the service manual it says "if you replace all of the parts you just listed.... to buy a new 600rr" hahaha
id try a ground, i had a civic that wouldnt spart and it wasnt gettin a good ground
id try a ground, i had a civic that wouldnt spart and it wasnt gettin a good ground
#6
Re: wtf is it..
my civic would turn over and do everything, but it wouldnt spark... i filed all the grounds down and it started up... id also pull out a ohm meeter out, and check all the wires that run to the coil packs. or find out what the pins are from the ecu, and check to see if its even sending out any signal
#13
Re: wtf is it..
weird thing about the stator..the clip coming out of there was kind of melted..but i cut it off and just spliced the wires back together..my bike was running decent but the last two months it had a problem where my bike wouldnt start unless it was leaned way over to the left...it was weird as ****
#15
Re: wtf is it..
Originally Posted by DoodleF4i
my f4i still wont throw spark,ive replaced the cam sensor,the igntion pulse sensor,the igntion,the cdi box,relays,rectifer,and wiring harness,coils and coil harness...everything appears to be plugged up...wtf else would keep it from sparking..
It's fu.cked sell it to me
#17
Re: wtf is it..
you have to get a connector to make sure the wires are connecting properly....then get some heavy duty elec tape and take the entire piece of wire.....this is a know fact with hondas....all types.
should be a simple fix....charge your battery and your good to go.
should be a simple fix....charge your battery and your good to go.
#20
Re: wtf is it..
did you change the plugs?
i recently sold my F4 to a friend and like a week later the thing wouldnt start. he ripped everything part, check everything, this and that. he was about to open it up and make sure the cams were lined up right when i told him to change the plugs. it fired right up.
but it was doin the same thing, would crank over but wouldnt fire. he even checked 2 of the plugs before but the other 2 werent firing thats what was stopping it.
i recently sold my F4 to a friend and like a week later the thing wouldnt start. he ripped everything part, check everything, this and that. he was about to open it up and make sure the cams were lined up right when i told him to change the plugs. it fired right up.
but it was doin the same thing, would crank over but wouldnt fire. he even checked 2 of the plugs before but the other 2 werent firing thats what was stopping it.