shortGSXR1000

i want to cut my stock windscreen down some so its even with the plastic on my gsxr 600. My legs are short has hell and this will help out with jumping up to high chair and heel clickers i think.

What did you cut it with? whats the best way?

will a regular cutting wheel work?

JohnnyP

sharp saw then sand paper on a sanding block

shortGSXR1000

sharp hacksaw?

JohnnyP

I use a very fine tooth wood saw hacksaw might work but because the blade is so thin it would be hard to keep a straight line..................Either way cut on the outside of your line and sand it smooth and straight

Regstunts

I just used a steel cutting wheel in a 4-1/2" angle grinder to trim my tail for a 12 bar. It was fast, that's for sure. Just don't let it get away from you. I'd draw a line and follow it rather than free-hand it.

-SKETCHY-

Take Off Your Upper.it Will Be Real Easy Then.

shortGSXR1000

yeah i have it off now to install the 905 stay thats why i was asking so i could do it before i put that sh** back together. I think i might try a cutting wheel on the 4 inch grinder... If i f it up i will just by another one and try again :YEAH

kj

Use a dremel w/ a small cutting wheel... then use the sanding attachment. Comes out nice.

CHAO5

I used a hacksaw, if you're going to put padding (like pipe wrap) as a cushion, it dosen't matter how it looks anyway. Thats right b!tches... that spot under my knees is soft and precious.

shortGSXR1000

how far did you guys cut it down.. I have a gsxr and it sticks about the uupper plastic about 2 inches. I was just gonna cut it there but anyone take it down further than that??

NINER

+1. Cut off any melted plastic after with a box knife. Ziptie on some cut plastic tubing and enjoy.

Suicidl

use rubber fuel hose and zipties on the edge then it is not bulky

Z-UNIT

scissors

GSXRoller420

used red handled right angle snips,drew out a nice curve before i cut anything off,and i went right above the plastic on the upper fairing looks good,used pipe wrap and zip ties on the edge

AzN~BoI_585

I used a hack saw...cuz i broke the bit I needed the night before...it just is a pain with a hack saw and i think i could have cut a straighter line after a 12 pack...but whatever i threw on sum pipe insulation and zip tied it down.

T-Dubby

That's what i used before