Mounting 636 Fi Bar
#2
Re: Mounting 636 Fi Bar
nope, prolly the easiest mounting bar i've ever put on... just line it up with the subframe (there are bends so you'll see exactly where is goes) and drill one side, put a bole in then measure from a fixed point the the end of the bar then measure the other side to make sure its straight, clamp and drill the other side... bolt it up, done!
you only have to cut a little bit on each side of the tail too
you only have to cut a little bit on each side of the tail too
#6
Re: Mounting 636 Fi Bar
My Subframe Is Ever So Slightly Tweaked.i Mean Just Barely From Scraping The Subframe.i'm Not Going To Buy Another One Right Now.hope It Doesnt Corkscrew Me Off
Thread
Thread Starter
Forum
Replies
Last Post