SmoothOperator

Usually everyone gives advice about wheellies but what about rolling burnouts? I drive an 04 busa and the problem im having is burnouts..Straight line rolling is fine but when i start to slow it down to go into a circle or figure 8 it just kicks out from under me everytime..If i start from a stand still i can do circles and 8's but its when im already in motion and go to slow it or put any kind of input on the steering it just kicks out.2 busted shoulders later im wondering if it just cant be done or theres something im not doing right please someone give me some advice...

kj

Don't rev it out so much... keep the rear spinnin slow.

SmoothOperator

yeh i know what your saying and from a stand still its fine ,but when im slowing to turn and i ease off the throttle and the rear grabs and lifts the front tire everytime,,then i shoot out and lowside,, i dont know if the front tire grips more at slower speed or not because i can keep it barley spinning once im into the circle but slowing it down from say 20-40 to the point where you turn into your circle it lose front grip when i ease off to get it to barlely spin ,,, i dont know i guess i just need to practice it more but im tired of getting hurt from the same thing,,maybe i'll move try somethin else

crtchrktrcr

keep fluctuating the brake.. you can't just hold it harder and do that.. learn to countersteer faster.. throw that ***** into circles quick, watch the guys from www.256north.com

jeffy0630

let go the brake a bit ur prolly rokin on it 2 hard r u kickin it out low or high ?

lockjaw

also try lowering you air pressure in the rear a bit. they helped me out alot

Lb3

dont listen to this advise.

Halliwood

lol

-Ludo

good way to bin a busa

lockjaw

is there something im missing.

kj

Lower presure will make it more likely to grab...

lockjaw

oh my bad not tryin to give any1 bad advice. on my gsxr if i had normal pressure it would spin out to fast. once i lowered the pressure it was much easier to control. could make it go fast or slow. never had a problem with it grabbing.?

Gixxer_R.i.F.

ya... if you have lower tire pressure it would allow more surface area to meet the ground! So it would grip more