keeth

f41's are notorious for cam chain rattle... in fact almost all the 600's are...


Buy the APE one it's worth the $$$

charsha1

hey i have a 929 same problem its a honda thing, but how do you know how much tension to use?

nags

Anyone know a cheap place to get the ape one?

atnuts

here ya go...good price & no bids
APE CCT for F4i

nags

anyone got a link to a howto or anything on how to install them?

Also, anyone know where the temp sensor is on the motor itself?

3824

what temp sensor - the engine coolant temperature (ECT) ??

3824

oh and here's instructions link on the tensioner

http://www.morrowmarsh.ca/concours/t...ner-manual.htm

nags

I believe thats the one.. gonna try changing it to see if that solves my temp problems

nags

well that doesnt seem so bad

3824

The ECT is under the air box so pull the gas tank and the air box ... then remove the throttle body then remove the coolant hose that is between stacks 2 and 3 from the thermostat housing. Disconnect the electrical connector (goes into the thermostat housing under the hose) from the ECT sensor. Unscrew the sensor and take it out - be careful of the sealing washer when you remove the sensor (unless you got a new one with the sensor). throw the new sensor in and your good to go - tighten the sensor to 17 ft.-lb. torque .....

nags

Am I ****in' blind? I looked all over and can't even find the cct

3824

i'll scan the pages from the manual and post them tomorrow ....

Ho_Hey

Check it out! this should make things a little easier and its got pictures

http://www.bossturbo.com/cbr/howto_cct.shtml

JOHN J

i got from cbr zone and it was a ***** to put in but it was worth every bloody knuckle. now the bike sounds great.