there r no stunters in my area so tryin to learn new tricks is a pain in the *** cause i have no1 there to give me advice or tell me what im doing wrong. I know for most every1 out there this trick isent a big deal but im about to try it for the first time and was hopeing to get some advice.

I have the bike parked in a wheelie at a stand still, i have it leaning foward so that its not resting on the 12 bar. i have it good and steady, 1 finger holding the rear hand brake and the other finger with the clutch pulled in. what do i do from here? i dont know if im suppose to relase the hand brake as i jump or hold it till the bike starts to fall or realse just b4 i pop the clutch? i have my idle at 3 and a half 4 grand, im not sure how much throtle im suppose to give, im scared im going to give 2 much, loop it and kill the subframe but at the same time im afraid im not going to give enough and end up going head first over the handle bars lol.
any advice would b greatly appreciated

 

this is how I do it, I suck at this though so others probably have better advise. push the bike forward, then jump to SS, wait a sec for bike to drop below BP...... then release clutch and HB simultaneously.

 

+1 thats how i do it

 

thats a good way to do it...one thing i do bc i do it jump to spreader too, is i release my clutch so that its just barley at the release point while im still on the ground...that way you know when you jump, you wont have to wait a second for the clutch release or end up giving it too much throttle...i let it drop just a tad and then blip it

heres a link to a vid when i was first learning them on my gsxr...sorry its sideways

http://vids.myspace.com/index.cfm?fu...deoid=52983683

 

same here i just get the bike to balance. I jump forward and onto the seat and as its coming down i release the handbrake and clutch and blip the gas to get it back to idle. I think thats what i do, lol. Im so used to doing it, it just happens. i want to learn how to stall them while i base off different objects.