Can any of you biys help ?

I need 12bar, bar brake for an F4i

 

might have a slightly bent 12bar in the garage, can't remember but I'll have a look if you want ?

That mungo's one? thought he had all the bits no?

 

Speak to Danny he has some moded handbrake masters in stock

www.justmotorcycles.net

 

diid you have a hand brake on the blade?
because i thought the rear masters were the same just have to change th plunger over,allthough i might be wrong.

 

he needs a master cylinder for the hb
unless he is going for a completly differnt set up then forgive me for talking bollox lol
i didnt have a 12 bar cause alstar was gonna help make me 1 when i got close to useing it

 

I've got an RS125 master, bought it on Ryant's reccomendation as he has the same one and says its brilliant (well he can scrape spreaders and hc's etc so must be good!)... I couldn't personally bleed it, I think the master is FINE , I didn't really put much effort into bleeding it as my 748 one works fine!

I'd take £25 for it, but heres the thing... as I don't know 100% if it works, I can bring it to spot on sat and can make sure it works proper and you're happy with before buying it.

If you can't find another before sat and wanna giive it a try, let me know and i'll bring it on sat.

 

sparks said the e word

 

Got all the other stuff other than the 12 bar and master for the brake.

Ill have that off ya nick if it not to buggerd

Can I have a look to see if that master will fit Sparks ?

 

DOH !

 

The master will definetly fit, just a case of whether it will definetly bleed or not.. the rs125 will work fine im just not sure if the seal has gone on this or not.. if i remember rightly i put it on my front brake but then realised it was for a single caliper so wasnt powerful enough for the twin calipers on front of CBR hence why its so good for a handbrake...

I'll bring it sat anyway and you can have a look if ya likes.

On second thoughts! it must work! it worked on the front brakes just not powerful enough for the dual calipers.

 

we should get a filter out on the e-word.

Can't believe you Sparks YOU'VE RUINED EVERYTHING!!!!!!!!!!

 

Was too busy thinking if the master works or not and frogot I'd mentioned the e word anyways the e word is a massive town so po-po wouldnt really be much closer to finding the spot anyways.... its like me saying "im going stunting in portsmouth tonigth" anyways it was edited after 20 or so mins so

 

i can bleed that up in 5 mins

 

what the fek is the e word?

 

What's the name of the spot where you go all the time? :P

 

Tim get that master off sparks i have one and it is really good as a first hb master. Like sparks said they are a bit awkward to bleed up but they work well for what they are. They also have an adjustable ratio which is handy to get it just so. It might not be a brembo 16x18 but i can slow high chairs down with it and **** like that so if ghostie is there and is good at bleeding brakes stick it on and get the ratio adjusted just right and you will be laughing. Just make sure that the little pipe that feeds goes back under the clip on/ bar and then the res sits on top of the bar facing forward and you wont get any airlockock nonsense. PM your tel number and I will send you a pic on the phone mate.

 

I set my 748 one up as toby says ^^^ with regard to the res positioning and had no problems, I can show tim how you told me to do my toby. the 748 one works too good to change hence why I didnt change to the rs one in the end.