New Stunter/Mechanic here from Stunters Edge Magazine
#1
New Stunter/Mechanic here from Stunters Edge Magazine
Hey ya'll. Thought my first post should be here.
I'm Clay H. I worked on a few of your alls bikes during Stunt Wars. I was the tech, and still am the tech with Stunters Edge Magazine.
I picked up my buddy's wrecked 06 R6(i know not a great stunt bike) for $500... bought an FI cage off ebay for $120, am half way done making a race harness for it as it will be just a stunter. The battery was dead so i put a free one from a zzr600 in it. Still need to bend out the front wheel, get the remaining piston back in the caliper, get some pads on the front, and finish the rear seat.
Tonight i succesfully chopped the front half of my wiring harness, mounted the gauges to the tank cover, and cut a big hole in the rear seat.
To be honest, I'm not great at custom work, but am pretty damn good when it comes to actually fixing stuff and making sure it will work properly.
Any time feel free to PM me with tech questions, or any sort of anything.
Hope I can fit in around here a little bit and learn a lot along the way.
Oh, and hopefully stuntersedgemagazine.com will be up soon, i'm waiting on our design dept. to take care of that.
I'm Clay H. I worked on a few of your alls bikes during Stunt Wars. I was the tech, and still am the tech with Stunters Edge Magazine.
I picked up my buddy's wrecked 06 R6(i know not a great stunt bike) for $500... bought an FI cage off ebay for $120, am half way done making a race harness for it as it will be just a stunter. The battery was dead so i put a free one from a zzr600 in it. Still need to bend out the front wheel, get the remaining piston back in the caliper, get some pads on the front, and finish the rear seat.
Tonight i succesfully chopped the front half of my wiring harness, mounted the gauges to the tank cover, and cut a big hole in the rear seat.
To be honest, I'm not great at custom work, but am pretty damn good when it comes to actually fixing stuff and making sure it will work properly.
Any time feel free to PM me with tech questions, or any sort of anything.
Hope I can fit in around here a little bit and learn a lot along the way.
Oh, and hopefully stuntersedgemagazine.com will be up soon, i'm waiting on our design dept. to take care of that.
Thread
Thread Starter
Forum
Replies
Last Post
stuntsquid101
Newbie Welcome Center
1
07-24-2016 09:51 PM