I got an 03 1000. The tip over sensor is sealed, does anyone know of a way to bypass it. I really don't want to cut it open and **** it up.

 

pump it full of silicone.

 

i'd say just disconnect it.

does yours even work that great? mine never shuts it off on my 929 and my frined looped his 03 gixxer 1000 in a parking lot and his slid across hte parking lot after flipping on top of him and it was still going so i guess his doesn't work either.

 

Hey, what you got to do is, there should be 4 little screws holding it together. Take them out and it will come apart, when you got it apart you will see a little ring in there that slids around just cut that ring off and put it back togethere. That is how i did it on my gsxr 600.www.stuntkingz.com

 

yeah i wish there were four little screws on the 03 1000 it is completely sealed, and the bike will not run without it connected

 

You can also remove it and put a small resistor in line where it was it'll be good. Not sure the exact resistor to use but if you pm DigityPBR and tell him I sent ya he should be able to help ya out. Also might pm Jay SOI, I know he rocks a 03 now.

 

ditto