I went down friday the bike fell and was sliding on the right side of the bike..i just replaced the clutch last week with new clutch plates and steel plates. i was able to ride it home but the clutch felt stiffer and would slip around 6k..what could be the problem? also i dont think i torqued it to specific torque but i didnt see the problem till right after i fell

 

First, glad you are ok.

I don't think the fall would change anything with the clutch internals but check out the clutch cable, routing, free play etc... Maybe the cable got jammed up somewhere or is not sitting in the perch well. Also make sure it is adjusted correct at both ends and that the nuts on the adjuster by the engine did not come loose.

 

thank you and yea i took off the fairing today and the cable looks a little damaged the part of the cable sitting against the frame. i hope thats all it is

 

yea glad your ok man! that would of been my advice about the cable. hope thats all it is. keep us updated

 

Glad your not too messed up. I agree with the rest. Cable.
But if not cable, check the lever adjuster and clutch actuating arm

 

thanks guys ill let you guys know as soon as i get the cable and adjust the lever .

 

yep it was just the cable replaced it..

 

Nice. Glad that was a cheap fix.

Are your tires worn out? You should get a new set so you don't go down easy again.


Nitpicking... Don't put your helmet on your gas tank, the gas vapors will break down the materials on the inside, make it stink, and it can fall off and get smashed.

 

my tires are worn out but not too bad.. but i wanna practice rolling burnouts until i get new ones.,.

and thank you for the tip i wont put it on the gas tank

 

YAY