stunting a 07 600RR
#1
stunting a 07 600RR
hey guys iv been stunting my 900RR for years. bought a 929 cause they are the new stunt machines and all around good bike. the problem is i bought it out of state paid a shipping company to ship it to me, and the son of a bitch stole the bike. i really would like a f4i to stunt. long story short i can grab a 600rr fairly cheap. with 800 miles on it so im thinking i will. my question is i know the tank covers are plastic and a pain the *** to dent ,but other than that are they ok for stunting ??? or should i say screw it and just look for the f4i ? thanks
#2
Re: stunting a 07 600RR
F4i would def be the route if your new to the game. I just bought rowdys old 08 600rr a few weeks ago and its a beast. You have to do an idle cable mod and disconnect the speed sensor to even think about turning the idle up... They tend to roll up on the bars and **** all your controls up too cause the motor mounts are so low... My cage was built with higher sliders but it was ruined when i got it so im probably going to buy a Sick cage and have it modified.
#3
Re: stunting a 07 600RR
so your sayig a regular cage like fi or sick inovations isnt gonna work ? did you dent your tank ? iv heard of guys melting that plastic cover to get it to form, but alot said its a pain in the *** to do it right
#4
Re: stunting a 07 600RR
You have to dent the metal tank then melt the top cover to fit. your ***.. Id say a heat gun would work best but i didnt dent mine it was already done.. they also built up the back of it so it has a higher ridge.. I imagine they used fiberglass or something similar.
Hope this helps theres info out ther just gotta look for it. Sucks Honda built the motor mounts so low but its something you have to deal with to ride a RR. You could save yourself a ton of trouble and buy a kawi but you'd be like everyone else and the trannys in those bikes are junk.
Last edited by tys0n.cbr; 07-31-2012 at 10:41 AM.
Thread
Thread Starter
Forum
Replies
Last Post