gsxr06

bike shifts gears fine for the most part, will go in and out of neutral just fine, but with the bike off and in gear I cant roll it around freely with the clutch pulled, doesnt seem like the plates need replacing is my clutch cable needing to be adjusted at the motor? or I found in the FSM a clutch lifter pin adjustment that I can do, but it requires taking the clutch assembly all the way out so just as much work as replacing the plates but cheaper.


any suggestions or input is appreciated

Dan_DGAF666

it will have some resistance

old man roger

some bikes roll easier than others and if you have an easy pull that can make it hard some times cause they may not fully disengage the clutch

I.Am.Hollywood!

Yeah i dont think anything is wrong with your bike mang... Ride it like you stole it!