big ben

so my cheater peg works great but i stand on the front of it cuz its so far back instead of standing on top of it if that makes sense....then it flips up.......if i put jb weld between the bottom of the peg and the bottom of the bracket will it hold the peg down even with my weight??? that all makes sense right??

vegasrider2005

remove the pin and but in a nut and bolt, did that to my old zx6r and it worked great

F3 stunna

or you can put a hose clamp around it too... That way if you do wipe out it'l just break the clamp, and not the peg...if you jb weld them when you crash you'll break the peg.. either way will work but hose clamps are cheaper than buyin pegs and peg mounts!!!!!

big ben

ive tried both.. bolt will break b4 it tightends and hose clamp just bends...

I_throw_nickels

it wont break if you use a good bolt

jcf4i

i used to always stick two pennies in the crack and hockey tape it. It works!!!

Towlieee

LOL that's what my ffriend ran on his, pennies


I think jb weld would work great, especially if you don't put a shitload. That way it'll still break the jb weld if you crash

MikeM

cut it off and remount it so it wont fold up

rockstarbilly

mate put a right hand side peg on the left it works great.

vegasrider2005

deff get a better bolt, dont know what your using but its got to be cheap