We have been tryin to get these out for a few years, but have been way too busy. We finally have them done. I am more than excited about these. They have a 1 in rise and a zero degree sweep. The adjustablity is amazing with the clutch/handbrake. My clipons i ran for the last few years(name i wont mention) worked ok, but getting a good setup with clutch/handbrake sucked! The bars are towards the windscreen approx 3/8 of an inch to keep the handbrake from bottoming out against the triple or fork when trying to roll it down. The last pic shows the difference between ours and a sweep type clipon. By the way, You can run these below the triple and still get a descent height due to the 1in rise. Check em out.

 

Sick and First

 

Ian i like the way the clamp is in-between the controls! Never thought of that nor could it be done. me likey! Look Sweet put up prices!

 

Intro price of 149.99. I think they might go up a little bit in the near future. With the rise, the block is almost twice as thick before machining, which means more expensive raw material and more machine time. I really like how they are set up. my old clipons were a pain to get the Hb and clutch setup right.

 

son of a buck those are baller.

 

Thanks buddy. Im def puttin on a beanie and goin ridin!!!

 

they dont sell beanie's in florida, they arent needed lol.

 

Ian looks good buddy! I wish u came out wit these a last year when I was harassin u bout them. I bought swatts from endless moto. Never
recieved risers or tubes and was out $125!!! With half a clip on set that didn't do me **** for good.

Cash for Junkers on these too???? They are still sittin in a ****** box from when I recieved my half *** shipmnt!

 

That sux man! I dont know if we can do cash for clunkers on these. We might be able to, but the discount wouldnt be near as high as on the other parts.

 

i just broke my clipons and was pissed at them, was thinkin convertibars, but i like that alot and the HB setup on the inside solves my problem.... i break long levers, but im getting a Brembo soon but didnt want to hack of such a pretty lever and u get the full strength with it on the inside.

well played Sick innovations. tons of companies are shooting up so u step up the game.


are u gonna have 50mm available?

 

those are 50mm.

 

Yup. 50mm. We have all other sizes too. Just a matter of changing the fork hole in the drawing.

 

badassness

 

nice job, looks great!!!

 

Nice!!

 

Do we get the bars too or just the clamps? I might be down to try a pair

 

Good question. I run LSL clipons and they have the 1 inch rise just like Sick's but the german made LSL's are alot more expensive. Ian, Do you have 43mm in stock yet?

 

i dont like em... sure theyre fine if you run streetfighter but for those of us that run full fairing having the clip ons mount in front of the forks(like all the other aftermarket ones) means no clearance for the fairing stay and upper. ive never had a problem with my hb hitting my fork from rolling it down with my 636 clip ons. also being a short guy, the clip ons forward like that makes me stretch over the tank even more, which is just uncomfortable.

 

nice! you should make 8 or 10 degrees as well

 

Put them on the opposite side, or turn them back a bit. .