TaNgElO6

ok was thinkin about getin some axle sliders for my 07 zx6r i just picked up and am in the process of setting up...

ive havent really looked to hard for them but i know powers makes them..

im not a tight wad but i think they are like around 80 bucks shipped a set..i thought that was kinda high....plus i didnt really wana **** with powers cause it took me like 4 months to get my race rails for my gsxr from them..talked to them like every week and was just told lies on top of lies

just wonderinng what people are running and how much they are

thanks in advance

classic customs

i run powers. same bike.

OnEWhEeLNEAL

I just hooked these up on my friends bike - buy some bmx pegs and a long threaded rod which you can buy at home depot - put a nut on each side and you're done for $25. **** that $80 ****

f4ibry

its called all thread rod at hardware stores for u dumbasses that have now clue what hes saying

TaNgElO6

yeh good call call on the bmx pegs ill try that......i found some driven ones that looked nice but they are even more expensive

thanks

OnEWhEeLNEAL

im a dumbass too coz i forgot what it was called

OnEWhEeLNEAL

Tough Luck

frame sliders work to with the all thread

*Tanus*

is there anyway to run them on an f4i frontend?

CYCOBOB

yep once you have the front wheel on and tight just pull the bolt out of the front axle slide the thread rod and sliders in and crankem down.

just keep a check on the pinch bolts on the axle i ran them on my cbr 900
and they worked well.keep the bolt so you can use it to preload the axle every time you change the front tire.
BOB

ScreamU2Sleep

drill a 1/2" hole in the bolt and use 3/8" all thread then there is no need to worry about the pinch bolts... It's what i did, but dont use them anymore.