Poor Man's cage extenders for $8.93
#1
Poor Man's cage extenders for $8.93
$8.93 at Home Depot.
2 - 3" 3/4" bolts
2 - 3/4 nuts
Now you can use your own method to secure them in there I just wrapped em with Industrial Strength black duct tape and pounded them in.
Also I only tried this on a SI cage. Again this is for people that dont have 60 bucks to spend and dont want their bike rollin over in those rare instances it goes down while training, like me. Later guys.
2 - 3" 3/4" bolts
2 - 3/4 nuts
Now you can use your own method to secure them in there I just wrapped em with Industrial Strength black duct tape and pounded them in.
Also I only tried this on a SI cage. Again this is for people that dont have 60 bucks to spend and dont want their bike rollin over in those rare instances it goes down while training, like me. Later guys.
#7
Re: Poor Man's cage extenders for $8.93
+1, Id lose the nut and stick the bolt all the way in,that way the tube doesnt get bent and make it hard to remove motor mount
#8
Re: Poor Man's cage extenders for $8.93
if your such a brokedick why not just buy a stick of UHMV or DELRIN rod and cut and lathe it into sliders??? its just as cheap if not cheaper and will actually disperse/absorb the impact
#9
#10
Re: Poor Man's cage extenders for $8.93
id just get the sliders...... cheaper than a new cage from a bent tube... and i picture leg pain in your future....... i had my bike lnd on my leg once on the puck and that was baaaad......i dont even wanna picture it with a bolt
#11
Re: Poor Man's cage extenders for $8.93
If its there to prevent roll over....the cracks or breaks in the ground are gonna grab that bolt (bend the cage tube) easier than the cage it self....plus if that ****** lands on you, you will instantly regret those bolts
#12
Re: Poor Man's cage extenders for $8.93
Feedback is what I wanted and got it, thanks. I thought delrin was expensive? If not Ill go that route, and the bolt gripping the ground I never thought of. Good point. Im going back to square 1.
#13
Re: Poor Man's cage extenders for $8.93
+1 to everything said. i know u can do a lot better for cheap.
id do as tanus said and loose the nut at least.
http://cgi.ebay.com/Plastic-White-De...d=p3286.c0.m14
id do as tanus said and loose the nut at least.
http://cgi.ebay.com/Plastic-White-De...d=p3286.c0.m14
#15
Re: Poor Man's cage extenders for $8.93
theres a hole that goes through the diameter of the slider and cage.....simply line up the holes and slide a bolt through