Metallic noise at 7Krmp 04 600RR
#21
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: Metallic noise at 7Krmp 04 600RR
cct's make a rattle sound at a certain rpm usually around 5 or 6 thousand rpms when they are bad and another way to check is have the bike in neutral hold it around 7 thousand rpm and when you let go of the throttle it will rattle as the idle goes down , usually sounds like bb's in a can
#22
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: Metallic noise at 7Krmp 04 600RR
you can also put a long screw driver on the cct and then put your ear on the handle of the screw driver, it will act like a stethiscope ..
rev the bike and listen then move the screw driver to another part of the motor and if the noise is loudest while on the cct it's probably that..
rev the bike and listen then move the screw driver to another part of the motor and if the noise is loudest while on the cct it's probably that..
#24
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: Metallic noise at 7Krmp 04 600RR
i used the screw driver trick for ever but i eventually got a stethoscope with a few different ends some solid some hollow , the hollow end is great for finding exhaust and vacuum leaks ..
#26
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
#28
Re: Metallic noise at 7Krmp 04 600RR
This happened to me. I heard a high frequency rattle around that same RPM range. I couldn't figure out what it was for like 2 weeks. It was the key ring on the end of my key laying on the tree. Put some tape on your key ring and see if that helps.
Thread
Thread Starter
Forum
Replies
Last Post