uponone270

i lowsided my bike last week and went to try and start it last night and my fuel pump wont cut on

so my question is were is the tip over switch and how do i bypass it???

and is there anything i should be looking for???

sdfkillz

i dont see why your tip over sensor would be malfunctioning from a simple lowside...sure ur kickstand switch isnt damaged or something else?

-SKETCHY-

your avatar is gross

sdfkillz

i know

-SKETCHY-

Thats gross Neil!

sdfkillz

hahha zing!

SxRacer108

the tipover sensor is a little black box under the seat mounted to the subframe in front of the battery tray...but i doubt that is what it is....like the above poster...check the kickstand switch and fuses first...

uponone270

sdfkillz your right cause i would just turn the key off and back on for that

is there a fuse box somewere ??? fuel pump fuse

can the kickstand switch be bypass ????????

SxRacer108

fuses are mostly under your seat where the battery is...most are relays though.... not too sure about in-line fuses....id say get a tester and trace the fuel pump wires back until you find the problem where the current stops flowin...

sdfkillz

so i take it the lights and stuff are comming on but ur fuel pump is just not priming? look at your kickstand and theres a switch on it, make sure its not damaged and check the wire comming from it and wherever it plugs in. i dont remember where the fuse box is on those bikes but its prob under the seat somewhere or under the tailsection if u remove it. check where youre fuel pump plugs in which i think is also under the seat..

uponone270

right

im going to go home at lunch and check to see if the switch is damaged or unpluged ...

and check under the seat and /or tail section to see if anythings unpluged ...

got it thanks

uponone270

if it is the kickstand switch can it be bypassed or does it have to be replaced??

Guy636

you can bypass the kickstand switch by just grounding the wires, another thing ive found on mine is that the relaloose during a hit and might cause the pump not to kick on all the relays and fuses are under the seat also if u look down where the gas tank bolts to the subframe u can look at the tip over and see if a wire got pinched that happens to me i cycle the key a few tmes and it will usually want to start

DIRTYJEFF636s

i know last sunday i blew my ignition fuse, couldn't figure out what went wrong. i'm tearing the bike apart at the lot

Guy636

check ur relays zip tie them down just them bouncing around can blow a fuse

uponone270

??

uponone270

GUY636
on the kickstand switch wire i would just wire them together right ???

1 on my f4i i have a mini fuse box with like 6 mini fuses....;.
2 does the 636 have something like that or is it single fuse through out the bike .... 3 and if so any one know were it is ....
4 in the tail ?? or under the seat cause i just see relays and 2 fuses ???

uponone270

need help cant get it started??

uponone270

fuel wont prime ???
i has power when i try to start it??

StuntinSS

I definatly 2nd that!