SI steel subframe for 05 636
#1
SI steel subframe for 05 636
Was wondering if anyone is running one or if someone else makes one.
Subframe broke any one had any luck on welding and adding some more strength to stock one
Thanks
Subframe broke any one had any luck on welding and adding some more strength to stock one
Thanks
#2
Re: SI steel subframe for 05 636
Bump for this thread. My sub completely snapped like a twig today and i didn't even scrape that hard.
Hows this SI sub fitting for u guys that have them? I'm about to buy one REAL soon...
Hows this SI sub fitting for u guys that have them? I'm about to buy one REAL soon...
#5
#8
Re: SI steel subframe for 05 636
Mine broke 3 times now..
first time I just welded the crack..
But the second time I only did small plates, and cracked them like a chocolate bar..
The last time I pretty much dismanteld it (stock) and cut out 3/8 aluminum plate and welded it to the sides right underneath the passenger seat latch.. Plates were about 8" long.... also put 1/8 gussets from where the bottom square stock ends.. its holding up pretty good now...
3rd times the charm.. i hope..
Curious on the SI subframe though...
first time I just welded the crack..
But the second time I only did small plates, and cracked them like a chocolate bar..
The last time I pretty much dismanteld it (stock) and cut out 3/8 aluminum plate and welded it to the sides right underneath the passenger seat latch.. Plates were about 8" long.... also put 1/8 gussets from where the bottom square stock ends.. its holding up pretty good now...
3rd times the charm.. i hope..
Curious on the SI subframe though...
#9
#10
#11
Re: SI steel subframe for 05 636
i'm actually waiting on a subframe I orderd on ebay cause I just broke mine so bad that it was unrepairable, I'm about to do the ill crazy aluminum plate job on the one I'm getting and I'll take pics of it
#13
Re: SI steel subframe for 05 636
i have 2 spares that are bent, and i just tweaked my nice one when i flipped forward. I might have a go at cutting one up and reinforcing.
how much are the steel SI ones?
how much are the steel SI ones?
#16
Re: SI steel subframe for 05 636
I've got the A-Town round bar with the bracing and I don't think I will have any subframe issues.....it's braced very well to the strong part of the subframe.
#17
Re: SI steel subframe for 05 636
#18
#20