buddy bought a crashed 98 gsxr 600 with no fairings in the front, There was a paperclip in one of the harness connectors up front, when i remove it, it wont turn over at all, plug that back in and turns over..

Check light is always on and turns over but wont fire. IS there a tip over sensor in it like a f4i?

I couldnt find any info on it and would appreciate what wires need to be jumped.

 

do u have spark?

 

I'm pretty sure there is a tip over sensor (that bike is fuel injected right?)

Except I don't think you can splice the tip sensors on gsxr's, I believe you gotta pull them apart and fill them with glue or somthing..

 

98 gsxr 600 =carbed

 

actually its a srad whatever

 

doubt its a tip over sensor. the tip over sensor is odd on srads compared to other bikes. alot of times its just one little wire not doing its job.

 

i dont have any of the front end stuff, no headlight or stuff that was in front fairing..

I have Spark and it started for a second without the tank on, Took fuel pump out and doesnt work, cleaned it and pump doesnt work, checked plug for it and its a 4 wire and i have no power to any of the pins.

SO there is something in the front wiring that is not connected so pump doesnt have power. The paperclip that is jumped makes it crank, has great spark and did fire for a few seconds of carb cleaner but i need to find what makes or needs to be completed for the pump to come on when i get a new one.

Thats the update, keep me informed on if there is anything you guys know about the wiring on these carbed 600's

 

gotta be the fuel pump..or the tip over isnt letting it run..run 12v to the fuel pump and if it works its something keeping it from getting power.

 

might end up hard wiring it from the stop switch or keyed power wire if i cant find the prob..