05-06 636 front end question
#1
05-06 636 front end question
my buddy is tryin to swap the 05-06 front-end onto his 04 636. he is trying to use the 05-06 tripple and clip-ons and he says the stem through the frame does not appear long enough to thread the mainstem nut on. anybody know if there is a trick to this?
i kept and flipped my 03-04 tripple and clip-ons when i swapped to the 05-06 forks/fender/rotors and i had zero problems but he doesnt want to do that. he wants to use the 05-06 tripple and clip-ons not flipped.
thanks in advance
i kept and flipped my 03-04 tripple and clip-ons when i swapped to the 05-06 forks/fender/rotors and i had zero problems but he doesnt want to do that. he wants to use the 05-06 tripple and clip-ons not flipped.
thanks in advance
Last edited by IV; 03-06-2009 at 03:59 PM.
#3
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: 05-06 636 front end question
use the 03 04 tripple ....
if he doesnt have one then maybe he could take the top spanner off to make a little more room for the shorter stem ...
if he doesnt have one then maybe he could take the top spanner off to make a little more room for the shorter stem ...
#4
Re: 05-06 636 front end question
#6
#7
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
#8
Re: 05-06 636 front end question
Yo Milt...thanks for the help bro...I finally got to a computer today...
Rodger..thanks for the help man....I will just use the 04 lower triple then it should work fine....this whole conversion is kicking my ***, lol...
Rodger..thanks for the help man....I will just use the 04 lower triple then it should work fine....this whole conversion is kicking my ***, lol...
#11
Thread
Thread Starter
Forum
Replies
Last Post