wannastunt21

Ok so i bought a bike a few weeks back and it was missing some engine bolts/mounts etc. Well the night i got it i stripped it down completely and now i have itback together and i can't get them damn thing to start. It turns over it just wont fire. I just pulled the plugs and they seem fine. Might jut go ahead and replace them and im going to check the coil. But if anyone has any advice or help in anyway i would be much apprectitive. I jonesin over here. Oh yeah itsa 600rr.

$$$$DINO$$$$

you checked for spark?

wannastunt21

how do i do that? this is my frst time puttin one together.

Nate-VMC

take a plug out and keep it connected to the coil. turn it over and see if it sparks.

wannastunt21

does it matter which plug?

Nate-VMC

also make sure you hear the fuel pump kick on when you turn the ignition on.
i would also drain the gas and put new fuel in it too. you have no idea how old the gas was thats in it..

ahhhhWHOA

every plug should have spark

Nate-VMC

if those dont help.. then i would venture to guess there is something else wrong with it... lol

mofat01

you test it like a battery. Put your tongue on the end and try and start your bike, if it tingles your tongue you got spark.

$$$$DINO$$$$

any plug that goes in ur bike...what you do is take the coil out,plug a spark plug in it,and ground the threaded part of the spark plug on the frame somewhere,then you try to start it,if you get spark they are good..move on to fuel..

wannastunt21

ok, i already did the fuel, it ran when i first got it...

50Outlaw

dear god...

take the bike somewhere

wannastunt21

I will if i have to, funds are strapped... I just tried each plug and didnt see a s[ark...

Nate-VMC

maybe you didn't hook something up right when you put it back together. make sure everything is connected right. Are the gauges on the bike? Not sure where the tip over sensor is on 600RR's but on 1000RR's they are on the gauges/upper/ somewhere and wont start unless they are in place...

$$$$DINO$$$$

well you messed up the wires go back re check

Nate-VMC

did you hold it up to something metal? like the frame or a screw driver? you need to have the end of the plug touching something metal.

wannastunt21

yeah gauges are hooked up, and from what i can see everything is connected... but i might be overlookin somethin... anybody recommend a shop around daytona?

0410R

chek the battery cause that battery wasent very good that we can say

Nate-VMC

check all your fuses?

dstb40

this might not be it but did you remove disconnect or lay over the tilt sensor? i took my bike apart forgot to put it back in the right position an my **** was dead for hrs till i realized what i did lol an if we're not near it we're all jus shootin in the dark wit suggestions. gotta be power(battery) signal(wires) or tilt sensor lol oh its got gas right?