theyre pretty much done, but i have a few questions.

1. What holds the tail section on under the front seat and in the rear?

2. What holds the undertray in the very front.

I need exact sizes if they are bolts (size and thread pitch) or push in clips ( diameter of clip with it not spread.

We have a bike here, but i didnt get any hardware with it. The subframe was off of the bike.

Thanks guys.

This subframe is gangster!

 

if its the same as my 08 then its all push pins there the same normal size push pin. do you know if that subframe will fit on my 08?

 

if you need me to bring down my mint 08 i can so you can see how it goes together just call me

 

Nice How much are they going to run?

 

399.99 steel

aluminum... not sure yet.

We can start accepting orders now, but the 1st one wont shop for another 2-3 weeks.

 

What up buddy. Is it an R6s? If so, yes it will fit..

 

ill call you tommorow and explain to youhow it fits if you want

glad its all coming together

 

Just two push pins on both sides of the seat. don't know what the diameter is since I dont have the pins with me. But they are just small center type push pins. The back is held on with a 4 mm allen bolt...I'm sure 07 will be able to exlplain it better when he calls ya. I'm pumped though!!!1

PICS PICS PICS PICS PICS!!!!!!!!!!!!!!!

 

the back also has a phillips screw that bolts the subframe to the battery tray

 

zipties!!!!!!

 

C4-REVOLUTIONS subframe is the best out there that is all.
http://www.c4-revolutions.com

 

I give him props for making them and they do look nice, but I beg to differ. You'll see why when I post pics.

 

If the tail is held on by push clips, I'll just get the diameter of the hole off the stock subframe. On the battery tray where it mounts in the front inside part of the subframe... Is that push clips as well? If so, were good and I'll post pics as soon as its back from the powder shop.

 

cant wait to beat one up!

 

they are.you could call him right now and he would send it out for you to beat on ..im running one right now not a month from now so i would say they are they best out there..not something thas not even ready

 

No, the battery tray is held on with an allen bolt on each side with an aluminum spacer between the subframe and nut. I think it is a 5 mm bolt that hold the tray through the subframe, with a spacer on the insidea and a 5 mm eggcorn nut...make sense?

 

they do look pretty..... I heard the sick one is almost identical? whats the difference? not like i care though, if you owned a honda you wouldent have to worry about junk like this

 

thats where your wrong actually you can call and ask him what I mean.

 

everything sick puts out has been proven by everyone they do not put out **** i am pumped about the new subframe and other r6 parts that are to come. i am not knocking the c4 ones but i like sick. The customer service is awesome. thats my

 

yeah you have to worry about little things NO POWER,being heavy and slugish spinning like a fat turd, cam chain problems,shity front ends,and every lot poser has your bike.......but strong subframes your right