?Spring Swap Inside Forks?
#1
Registered User
Thread Starter
Join Date: May 2007
Location: Indianapolis, In, US
Age: 36
Posts: 442
?Spring Swap Inside Forks?
How to you get the springs out of 03 636 forks? I got the forks apart and got my seals replaced but I cant figure out how to get the spring off it because I just got a set of hyperpro springs to replace my factory springs. Thanks alot
#6
Re: ?Spring Swap Inside Forks?
no, front springs can be compressed by hand, theres a special tool we have at the bike shop to get them apart, its a clip that you slide in to them after you compress them, when installed it keeps them compressed so you can loosen the nut that holds them together.
#9
Registered User
Thread Starter
Join Date: May 2007
Location: Indianapolis, In, US
Age: 36
Posts: 442
Re: ?Spring Swap Inside Forks?
ok cool thanks man. I just ran to the local auto zone and got a spring compressor but they are to big and wont fit into the spring gap to get a bite to cmpress
#10
Re: ?Spring Swap Inside Forks?
ya i remember that happening on my dirt bike shock, did u try to tighten the spring down as far as it will go and putting a bunch of hose clamps or heavey duty zipties around as many coils as you can and then try to taking it off. if not ill ask the techs on monday
#14
Re: ?Spring Swap Inside Forks?
I don't know what size it looks like because i'm not around my bike. But if it's the same size as the swingarm nut on the frame, then that one is a 24mm
Last edited by SAMBO; 12-06-2008 at 08:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post