f4i easy pull mod ?
#21
#25
Re: f4i easy pull mod ?
check this link and you don't have to weld juse go to lowes and buy a piece of flat stock very simple
https://www.stuntlife.com/forums/2-s...h-arm-mod.html
https://www.stuntlife.com/forums/2-s...h-arm-mod.html
#26
#27
Re: f4i easy pull mod ?
i found an extra clutch arm in my extra parts so im gonna use that and try doing this today and to make sure just go 1/2 inch right with the bolt on method?
can i do this while the clutch arm is still on the bike?
can i do this while the clutch arm is still on the bike?
#29
#31
Re: f4i easy pull mod ?
You can go 12.5mm or 1/2" on the f4i, but you WILL have to bend it past the motor case, and past the frame.
I've done 4 f4i's, all exactly 1/2", and they all worked fine.. But it is kind of a pain to install the arm.
Btw with a MSR + 1/2" extended arm, I still only use half my total clutch pull at the lever
A MUST have mod, no longer does my clutch finger ever fatigue.
+1 ya can definitely go longer with a bolt setup, but I just wanted my **** done for free, and ez, plus I like to play with the welder any chance I get!
I've done 4 f4i's, all exactly 1/2", and they all worked fine.. But it is kind of a pain to install the arm.
Btw with a MSR + 1/2" extended arm, I still only use half my total clutch pull at the lever
A MUST have mod, no longer does my clutch finger ever fatigue.
+1 ya can definitely go longer with a bolt setup, but I just wanted my **** done for free, and ez, plus I like to play with the welder any chance I get!
Thread
Thread Starter
Forum
Replies
Last Post