Stubbz

anyone have any ideas on where to cut into the plastics to install an SI cage on an 03-04 636. from the picture on thier website you can tell sort of where it is but wasn't sure if anyone knew of an easy way to do it or not. my buddy had a hell of a time with his 03R6 and ended up with shitty lookin holes in wrong places by time he got it right.

Stubbz

well i found the directions on the website actually but anyone else have any good ideas, something that maybe is easier or worx better

John LegionST

give ian a call, he can give better directions probably...

honestly you have to just line it up best you can and take your time... measure twice, cut once...

maybe if you have or can get your hands on a set of beater plastics use those as a practice set and once you get it right use it as a template...


hope that helps...

Stubbz

alright thanks man, i did find directions on how to notch out the plastics on the SI website, so i think i can figure it out, i was just curious if anybody had any other ideas. Thanks tho