Clutch actuator arm extension mod kicks ass....Thanks Rog!
#62
#63
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
#65
#67
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: Clutch actuator arm extension mod kicks ***....Thanks Rog!
you want get scared ? look at how the end of your clutch cable is made...lol
shitty *** pot metal melted on to some steel wire....trust me even a shitty weld is about 100 times stronger then the little tit on the end of your clutch cable
shitty *** pot metal melted on to some steel wire....trust me even a shitty weld is about 100 times stronger then the little tit on the end of your clutch cable
#69
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
#70
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: Clutch actuator arm extension mod kicks ***....Thanks Rog!
6101-T6TempTensile Strength (ksi)Elongation°FUltimateYield% in 2"-320433324-112363020-1834291975322819212282520300211920400107405004.83. 38060032.31007002.51.8105
this is the tensile chart for a certain type of aluminum but i can't find one for steel
[edit]ok that didn't post at all what it looked like when i copied it.......lol
this is the tensile chart for a certain type of aluminum but i can't find one for steel
[edit]ok that didn't post at all what it looked like when i copied it.......lol
#72
Re: Clutch actuator arm extension mod kicks ***....Thanks Rog!
It not useless if you are designing things that you don't want to break.
#73
#76
#77
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
#78
Re: Clutch actuator arm extension mod kicks ***....Thanks Rog!
Ok after reading this thread I decided to do mine took me 10min. cut actuator at bend on 636, added about 5/8 scrap metal from a bucket I have. welded it grinded it painted and it is like BUTTER my friends it is a must and so easy thanks OMR I used what u said and had no problems except I suck at welding small peices no more finger fade when ss combo's and stalls right and left hc fig 8's ok I can't figure 8 them but I stall like **** thanks again on the tip HawaiianDave!
#79
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: Clutch actuator arm extension mod kicks ***....Thanks Rog!
it's nice huh..lol
clean and lube your cable and route it so it doesn't have any sharp bends and it gest even better
clean and lube your cable and route it so it doesn't have any sharp bends and it gest even better