Where can i find a dirt bar triple clamp to replace the bolt on risers i have on my F4i?

 

warped toys sells a kit 2 mount up dirtbike bars...BUT if ur running your front fairing n not like a dirtbike headlight you'll need to make about a 1-2" spacer that dosnt come with the kit to go inbetween the top triple clamp and the bar mounts. make shure to make proper measurments on the triple clamp before you drill your bolt holes so that the bars will be straight and even while ridin down the road. the factory clutch cable and throttle cabels are long enough if you route them right but you'll hav to extend all the wires on the right handle switch...i mounted my left switch just below the top triple clamp ont the fork tube with a couple zip ties because there was no room on the left side of the bar with my handbrake on the left side..hope that helps. -Steven

 

vortex makes an aftermarket triple clamp for moto bars I believe. It's a shame nobody makes one for a 636. The kawasaki stock triple clamps are sooo brittle to be drilling into.

 

give ho-hey a few more weeks and hit him up! it will be worth the wait i promise!

 

Is he getting rid of one?

 

I got this on my F4i - from Full Throttle. You can use a damper too.

http://www.fullthrottleinc.net/store...ge.php/pID/195

 

Is that why he wanted a 03-04 636 donor bike? That would be ******* ill.

Those full throttle inc bars are SICK.. looks like a great idea.. it's a shame they only make them for that bike... make them for the 929.. they would fit a wide range of bikes as a lot I believe are the standard 50mm at the top.

And I stand corrected... it wasn't vortex, it was the lsl triple clamp.

 

damn thats nice. how much does that run?? I have a machine shop and was thinking about making one if they are too pricey.