bent 905
#1
bent 905
the right side rear mounting point bar has been bent....now the 14 inch bolt doesn't reach the nut thats welded on there.
i tried heating it up with a blow torch for a long time and then tried prying it back while it was hot....it wouldn't ****** budge.
any ideas?
p.s. 905 is a piece of ****!
i tried heating it up with a blow torch for a long time and then tried prying it back while it was hot....it wouldn't ****** budge.
any ideas?
p.s. 905 is a piece of ****!
#3
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: bent 905
you must have tried a propane torch....
they don't get very hot unless your heating very thin steel
take off the cage and put the bent part in a vice it will bend like butta...lol
they don't get very hot unless your heating very thin steel
take off the cage and put the bent part in a vice it will bend like butta...lol
#8
Re: bent 905
hes an old man so hes up for his morning coffee.
use a piece of threaded rod for the rear bolt. 905 sucks big time! all my buddies out here are sponsored by them and i refuse to use them they bend soooo easy. so ill stick with my homemade cage.
use a piece of threaded rod for the rear bolt. 905 sucks big time! all my buddies out here are sponsored by them and i refuse to use them they bend soooo easy. so ill stick with my homemade cage.
#9
Re: bent 905
thx for the tips
btw, the 14" bolt DOES reach it, but when it does, its crooked, meaning its not aligned with the nut.
im thinking about just rewelding that 10mm nut crooked(in the opposite direction) to match it? think itll work?
btw, the 14" bolt DOES reach it, but when it does, its crooked, meaning its not aligned with the nut.
im thinking about just rewelding that 10mm nut crooked(in the opposite direction) to match it? think itll work?
#10
Re: bent 905
try take`n it off and line that part up and get it started 1`st,then heat that part ,this way you`ll have more leverage to bend it.this is if it`s not bent bad,if so listen to OMR,he is old and wise for all of us grasshoppers
#12
Re: bent 905
lol, i wanna a ****** tygershark but i don't got the dough.
anyway, got it fixed yesterday morning, $50...for some reason, SL was down for a long *** ****** time!
grinded off old welding/nuts...we put the 14" bolt through, screwed 2 10mm nuts onto the other side, then a small weld on it (as it was on the bike)..to get the right angle.
took it off, finished welding, the guy gave it a little black spray paint..and walla!, it mounted right on.
came home, installed some sliders....now im gonna go and practice some idle ****! :YEAH
anyway, got it fixed yesterday morning, $50...for some reason, SL was down for a long *** ****** time!
grinded off old welding/nuts...we put the 14" bolt through, screwed 2 10mm nuts onto the other side, then a small weld on it (as it was on the bike)..to get the right angle.
took it off, finished welding, the guy gave it a little black spray paint..and walla!, it mounted right on.
came home, installed some sliders....now im gonna go and practice some idle ****! :YEAH
#14