who is this and what in the hell happend?
#21
#27
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: who is this and what in the hell happend?
if they are leaking from around the tube at the bottom they can break just from putting down a wheelie........
i would change them if i were you or at least tighten them but if there leaking it might be to late for just tightening them
i would change them if i were you or at least tighten them but if there leaking it might be to late for just tightening them
#30
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: who is this and what in the hell happend?
Ok There Is A Set Screw On The Inside Of The Fork ,on The Bottom Part That Your Axle Goes Through
Take Off Your Wheel And Put The Axle Back In
Loosen The Set Screw And Thread The Fork Tube[the Chrome Part]back Into The Bottom Of The Fork[the Powder Coated Colored Part]
If Your Forks Are Already Leaking There It May Be Too Late For Just Tightening
This Is Only An 03 04 Problem 05 06 636 Forks Are Made By The Same Company That Make Honda Forks So They Do Not Have This Problem I Am Told
Take Off Your Wheel And Put The Axle Back In
Loosen The Set Screw And Thread The Fork Tube[the Chrome Part]back Into The Bottom Of The Fork[the Powder Coated Colored Part]
If Your Forks Are Already Leaking There It May Be Too Late For Just Tightening
This Is Only An 03 04 Problem 05 06 636 Forks Are Made By The Same Company That Make Honda Forks So They Do Not Have This Problem I Am Told
Thread
Thread Starter
Forum
Replies
Last Post
KGAP
Newbie Welcome Center
0
07-10-2014 07:22 AM