MSR Pro Rapter is the shizzle!
#81
Re: MSR Pro Rapter is the shizzle!
Wish I would ve thought about that before I wasted $50. Guess with age comes experience. How is everyone else lovin this piece, I dont get it, its been nothin but trouble since I took it out of the pack. I could stack my stock lever so much easier and put it where I wanted it. gaaaabage, how the hell are yinz gettin the cable in the hole and threaded through the top adjuster? mines too short, or are you gettin diff cables?
#82
Re: MSR Pro Rapter is the shizzle!
Wish I would ve thought about that before I wasted $50. Guess with age comes experience. How is everyone else lovin this piece, I dont get it, its been nothin but trouble since I took it out of the pack. I could stack my stock lever so much easier and put it where I wanted it. gaaaabage, how the hell are yinz gettin the cable in the hole and threaded through the top adjuster? mines too short, or are you gettin diff cables?
#84
Re: MSR Pro Rapter is the shizzle!
I was trying with the perch off the c/o.There wasnt enough in mine. I ended up disconnecting the cable at the bottom hookin up the lever then reconectin at the bottom. Maybe my cables not stock? Anyway its on now, used it last night and I must admit it is easier.
#89
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
Re: MSR Pro Rapter is the shizzle!
yes there is i think mike m did it on his , i think...
well i don't remember but you could maybe go up at an angle if there isn't enough room to go straight out ....even 10 mm more would make a differance
well i don't remember but you could maybe go up at an angle if there isn't enough room to go straight out ....even 10 mm more would make a differance
#90
Re: MSR Pro Rapter is the shizzle!
hmm i gotta find a welder now, any way you could make one and send me it? :D
#94
Re: MSR Pro Rapter is the shizzle!
if the pic is dark turn up the brightness on your monitor......
just cut the lever about an inch from the cable and weld in about 3/4 of an inch of flat steel that is close to the thickness of the lever it self then just grind the weld flat and your done ...
you just want to make the clutch release lever a little longer to increase the leverage
#100
Re: MSR Pro Rapter is the shizzle!
if the pic is dark turn up the brightness on your monitor......
just cut the lever about an inch from the cable and weld in about 3/4 of an inch of flat steel that is close to the thickness of the lever it self then just grind the weld flat and your done ...
you just want to make the clutch release lever a little longer to increase the leverage