Joe 636

I think the suction hose idea sounded best...good luck.

verticaljay

Pull off your headers and drop the oil pan. It shouldn't take long.

thewibb

Hey bro, you can't reach it with one of these can you???

I've used them for everything imaginable and sometimes you can get it on things you wouldn't otherwise touch. It's not a magnet, but it has a good sized 4 point claw that comes out when you depress the top.http://www.harborfreight.com/cpi/cta...temnumber=1826

DBOUNCE1

already did that, it fell back into like the transmission part through the square hole in the reaar of the oil pan

DBOUNCE1

why do i need to take the air box off?

ahenry

i think he may be talkin about oil gettin in your airbox

DBOUNCE1

ahhh forgot about that

HighStyles

if its in your tranny its alot easier to get to and yeah.. oil in the box.. but anyways take off the clutch cover and see if you can see it.. most likley if you pop that off you might just be able to lean the bike over but since it is in the tranny now.. pull the battery... one bump of the ignition and you went from 15 dollar gasket to 600 in shop cost... you'll get it just be smarter than the chunk of metal... good luck.. you might have to remove the clutch discs but thats cake.. just make sure you leave them in the order you took them out

HighStyles

oh and i only told u to take the box off cause if you never had it happen you'd start the bike.. and it will smoke like a ***** and stink like sulfer.. didn't want you to think that maybe something else was in there and f'd it up...

DBOUNCE1

right i know what you mean man but my bike has been sittin there with the oil pan off for 4 days now just about all the oil in out by now

Justin-

get it out i had a motor go out ( BLOW kNOCK FU[K UP) what ever u want to call honda or not u have to find that $hit

DBOUNCE1

going home here in a little bit to give it a try i'll post up tomorrow what happens

DBOUNCE1

well i lifted it up last night on the forklift i forgot my camera at home i was gona take pics of it hangin there it was pretty neat lookin. anyway i lifted it up real slow like nothing came out and i couldn't hear it either

then blew in there with the air hose nothing came out nor could i hear anything rattling around in there

then i flushed it with Kensol (a parts cleaner that's highly pressurized) again nothing even a rattle

so then i just tried dropping the forks on the lift real quick to like try to jar it loose incase it was lodged i did this a couple times and even let it down slow too to see if i could hear anyhting momving or shifting inside again nothing


so should i just assume that it fell out maybe in transport or some other time and i just didn't hear it?


what now? i'm about ready just fvck it and fill it with oil and fire it up and see what happens


what do you guys think?

Hazen

+1

Then start that hoe up.

DBOUNCE1

any other opinions?

RuntStunts

Give it a shot. Did you check the truck bed and everything to see if ti rattled out?

skinnyR!

kABOOM

ahenry

take the clutches out, its better to do all this work for free then have to buy a new motor. thats the way i look at it

DBOUNCE1

I Already Did That Too

ahenry

damn, spend a little more time looking over everything again, then i gues go for it.