Endo ?
#1
Endo ?
OK I WAS PRACTING ENDOS FOR LIKE 20 MIN. AND AFTER A WHILE I COULD PULL MY LEVER ALL THE WAY TO MY BARS AND NOT STOP.I WAS WANDERING IF ANY BODY ELSE HAD THIS PROBLEM.MY ROTERS WERE HOT AS FU*K. IS THIS THE PROBLEM?AFTER I LET MY BIKE SIT FOR A BIT THE PROLBEM STOPED.BUT I HAVENT DONE THEM SENSE BECAUSE I DONT WANT THEM TO FU*K UP..
#2
Re: Endo ?
this is what i would do. change brake fluid as it sounds like you have boiled yours. use dot 4-5. get some braided lines as i found these help. check your pads. what sort of pads you using? also if your rotors are really hot, i try not to let the bike sit on the one spot or you can warp your discs. ride the bike round for a couple of minutes without using the brake to much to let the rotors cool down. also check to make sure your brakes are bleed properly. hope this helps
#4
Re: Endo ?
Get 'em higher!!! If they're low, you're gonna be using more brakes and they will fade. Stock Honda pads are good. Don't change them unless they're through. Braided lines are a must.
#5
Re: Endo ?
+1 for braided lines. ive got a braided hb line on my 929 and my line going from my foot master cylinder to my caliper is a stock line, if i pull in my hb i can actually watch my stock rear brake line move and my steel line stay put. i'll be changing the other line over this weekend.
Thread
Thread Starter
Forum
Replies
Last Post